Serpent 909557 17-Tooth Aluminium Pinion for Centax  [SER909557]

Serpent SER909557 Centax gear-pinion Aluminium 17t
Price:
NZD$22.84
Brand:
Serpent
Model:
SER909557
Condition:
Brand New
Write a review

Tune Your Centax Clutch with Serpent 909557

Hobbyists and club racers looking to refine drivetrain response will find the Serpent 909557 Aluminum Pinion Gear a practical choice for Centax clutch assemblies. It is engineered to reduce rotating mass while maintaining the strength required for regular track use.

7075-T6 Aluminium Craftsmanship

Produced from 7075-T6 aluminium, this pinion trims weight from the rotating system without compromising structural integrity. A hard-anodised finish offers added protection against abrasion.

Engineered 17-Tooth Performance

The 17-tooth design gives consistent engagement and efficient power transfer, suiting drivers who want predictable throttle response and smoother acceleration characteristics.

Do I need to change other gears when fitting this pinion?

Not always. If the tooth count or pitch changes your overall ratio significantly, you may want to check the spur gear and final drive to retain smooth mesh and handling characteristics.

Can this pinion handle regular club racing?

Yes, the 7075-T6 aluminium construction with hard-anodised treatment is suitable for regular club use, offering a good balance of lightness and wear resistance.

How do I check gear mesh after installation?

Install the pinion, rotate the drivetrain by hand and observe tooth contact; adjust the motor or pinion position to achieve even contact across each tooth without binding.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved