Serpent SRX8 Gen4 FR+RR Brake Cam 601369  [SER601369]

Serpent SER601369 Brake cam FR+RR SRX8 Gen4
Price:
NZD$26.53
Brand:
Serpent
Model:
SER601369
Condition:
Brand New
Write a review

SRX8 Gen4 Brake Cam Replacement (Front & Rear)

Designed for the Serpent SRX8 Gen4, this brake cam serves the front and rear linkage positions. It replaces worn cams to help retain the intended brake geometry without changing the chassis configuration.

Compatibility is specific to SRX8 Gen4 platforms, so confirm your model before ordering. To install, remove the old cam from the lever assembly, carry over any serviceable linkage parts, install the new cam, and check full-range lever movement and pad engagement.

Use this part for routine service and fine tuning to keep brake bite consistent across sessions. Minor servo neutral or linkage length tweaks may be needed after fitting to restore exact pedal feel.

Technical Details

  • Item Brake cam FR+RR
  • Material Not specified by manufacturer
  • Model Number SER601369
  • Compatibility SRX8 Gen4

A handy spare for SRX8 Gen4 owners looking to maintain dependable brake operation and support precision setup changes.

How long will the replacement cam last under normal use?

Lifespan depends on driving style and conditions. Regular inspection for wear is recommended and replace the cam if you notice increased free play or inconsistent bite.

Is the material specified?

The manufacturer does not list the material. Check the part for stress signs during routine maintenance and swap if any cracking or deformation appears.

Can I run the car if the cam shows minor wear?

Minor wear may be tolerable short term, but for consistent brake feel and safety it is best to replace the cam before performance degrades noticeably.

Any maintenance tips to extend life?

Keep linkage free of grit, inspect pins and clips regularly, and avoid excessive binding in the brake assembly to maximise cam life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved