Serpent SRX8 V2 Aluminium 21deg KPI C-hubs L+R - 601389  [SER601389]

Price:
NZD$0.00
Brand:
Serpent
Model:
SER601389
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Precision Aluminium C-hubs for SRX8 V2

The Serpent SER601389 C-hub pair provides left and right 21deg KPI hubs manufactured from aluminium for the SRX8 V2 platform. These units are intended as an aftermarket replacement for the original plastic hubs when a more rigid steering pivot and repeatable geometry are required.

Designed to establish a dependable KPI (King Pin Inclination) datum, the alloy hubs allow setters to reproduce steering changes reliably. The stiffer material reduces flex relative to plastic, delivering sharper steering input and helping to preserve wheel alignment during energetic driving.

Installation follows standard SRX8-series procedures: remove the factory hubs, move over bearings and any reusable hardware, then mount the SER601389 parts using the original fasteners. After fitting, verify wheel alignment and kingpin angles, then carry out a short test to confirm the setup before final adjustments.

Compatibility

  • Serpent SRX8 V2

If you need a metal upgrade for consistent KPI and crisper steering on an SRX8 V2, these aluminium C-hubs offer a reliable option for precise front-end fine-tuning.

How do aluminium C-hubs hold up compared with plastic?

Aluminium resists deformation better than plastic under load, so these hubs typically last longer in high-stress setups, though they may transfer more shock to adjacent components.

Are the hubs corrosion resistant?

Aluminium has good natural corrosion resistance, but regular inspection and cleaning after wet or salty conditions will prolong service life.

Will repeated impacts cause permanent damage?

Severe impacts can dent or bend aluminium parts; however, they are generally more dimensionally stable than plastic under everyday racing stresses.

What maintenance do these hubs need?

Inspect for nicks, check bearing seats for wear, and ensure fasteners remain torqued to spec. Replace if any deformation affects alignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved