Servo Housing Set for Futaba S9452 - FUAS4147  [FUAS4147]

FUTABA S9452 SERVO CASE SET AS4147 EBS3340 (W/O PACKING)
Price:
NZD$6.48
Brand:
Futaba
Model:
FUAS4147
Condition:
Brand New
Write a review

S9452 housing overview

This FUAS4147 case set serves as a replacement shell for Futaba S9452 servos, intended for maintenance and rebuild tasks in RC kits. It supplies the outer body and mounting points needed when the original housing is damaged or worn.

Use this housing when the existing shell is cracked, stripped, or after internal servicing where the electronics and gears have been removed for repair. Note that the set does not include internal packing or electronic components.

Assembly guidance: remove the servo cover with care, label or retain fasteners and small parts, move the gear train and PCB into the new shell, and check the gear mesh and horn alignment before finishing the build. Ensure your servo carries the S9452 code prior to starting work.

How do I confirm this will match my servo?

Verify the model marking on the servo body; the FUAS4147 is matched to the S9452 designation. If the marking differs, do not proceed without checking measurements and mounting points.

Is any internal hardware included with the case?

No internal hardware is provided. The product supplies only the external case components; gears, PCB, bearings, and packing must be reused or purchased separately.

What should I watch for during reassembly?

Keep parts in order as you remove them, ensure bearings sit flush, set gear clearance correctly, and confirm the servo horn is centred before tightening the final screws to avoid binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved