Serpent 903698 Viper 988 Fine Tuning Bushings  [SER903698]

Serpent SER903698 Servo saver shaft bushing (2) S988
Price:
NZD$18.05
Brand:
Serpent
Model:
SER903698
Condition:
Brand New
Write a review

Fine-tune Your Viper 988 Steering

If you want tighter steering control on your Serpent Viper 988, the Serpent 903698 Servo Saver Shaft Bushings are a small upgrade with clear benefits. They reduce slack in the saver assembly so steering inputs translate cleanly to the wheels.

Rugged Materials for Racing

These bushings are produced to resist wear from frequent steering motion and aggressive track conditions. The Serpent 903698 pieces maintain alignment of the servo saver, helping to keep steering consistent lap after lap.

Simple Swap Fit

Specifically matched to the Serpent Viper 988 servo saver, installation is a straightforward replacement job. Most hobbyists can fit them during routine service without specialised equipment.

Can I use these with a high torque servo?

Yes, the bushings support reliable operation with most hobby servos, including higher torque units, as long as the servo saver and linkages are set up correctly.

Do I need special tools to fit them?

Basic hand tools are usually enough. A small press or careful hand fit will seat the Serpent 903698 bushings; avoid forcing them to prevent damage.

Are these a direct replacement part?

They are made to match the servo saver geometry of the Viper 988. Check the existing bushing type and orientation before replacing to ensure a direct swap.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved