This Hirobo HI0414484 servo stay serves as a compact mounting bracket that sets servo height to 12mm. It secures the servo so the output shaft maintains correct alignment with the airframe mounting points, which helps keep control link geometry consistent.
Use this stay when exact servo height and repeatable placement are required, for example when swapping in a replacement bracket or matching multiple servos during assembly. The part is listed among Eagle Freya helicopter parts, so check fitment against your model's hole pattern before installation.
Fitting tips: ensure the servo spline is oriented to engage the control linkage, use the existing mounting holes where possible, and progressively tighten fixings to avoid distorting the bracket position. This product is an accessory for RC helicopters only.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
