Serpent 500576 Rear Carbon Shock Tower for SDX Chassis - Precision Carbon Part [SER500576]

Serpent SER500576 Shocktower Rear Carbon SDX

Price:

NZD$63.89

Brand:

Serpent

Model:

SER500576

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Refine SDX handling with the Serpent 500576 carbon rear tower

The Serpent 500576 Rear Carbon Shock Tower is crafted from quality carbon fiber to reduce weight while keeping rigidity where it matters. Fitted to the SDX chassis, this rear tower helps the suspension maintain consistent geometry for better control on varied surfaces.

What makes this tower stand out

Material: Premium carbon fiber chosen for durability and low mass.
Compatibility: Purpose-built for the SDX chassis to ensure correct alignment.
Performance: Boosts rear suspension stability for more predictable handling.

Specifications

Material: Carbon Fiber
Chassis Compatibility: SDX
Position: Rear

Suited to tuners and racers wanting a tidy, dependable upgrade, the Serpent 500576 Rear Carbon Shock Tower improves rear-end feedback without adding unnecessary weight.

Is the tower compatible with aftermarket shocks?

In most cases yes, as long as the shock top mounts match SDX rear tower spacing; confirm mount dimensions before swapping in large-diameter shocks.

Will a carbon tower affect handling balance?

Because carbon saves weight up high, it can slightly change weight distribution and responsiveness; tune spring rates and ride height after fitting.

Should I use thread locker on the screws?

A medium-strength thread locker on metal-to-metal fasteners is recommended to prevent loosening, while avoiding excess that could make future removal difficult.

Any setup tips after installing?

After installation check rear camber and droop travel, then run a few laps to fine tune damping and spring rate to suit the new stiffness.