Slash 2WD Steering Linkage Upgrade SLA2W160ST for TRAXXAS by GPM  [SLA2W160ST]

Overview of the Slash 2WD tie rods

A set of spring-steel adjustable steering rods made for 1/10 Slash 2WD short course rigs, intended as direct replacements to improve toe stability and steering feedback under load. The emphasis is on component strength and easy length adjustment rather than showy finishes.

Construction and purpose: these tie rods use spring steel for durability and bend recovery, with a beefed-up section where steering loads are highest to reduce flex. The turnbuckle-style adjuster makes it quick to set toe-in or toe-out as part of routine setup.

Fitment and setup: the rods install in place of stock linkages on compatible Slash 2WD setups, featuring standard threaded adjusters and lock nuts to prevent unwanted length change during running. Altering length changes static toe to tune handling balance; always check servo horn clearance and confirm wheel alignment at ride height after fitting.

What is in the box: the set includes the required screws and lock nuts so you can fit the linkage without hunting down extra hardware. Inspect threaded joints for correct engagement and tighten lock nuts once adjustments are final.

For racers and hobbyists running Slash 2WD short course cars who prefer a straightforward, stronger steering link, these spring-steel adjustable tie rods deliver durability and convenient tuning in an aftermarket package.