Slash 4x4 aluminium C hub replacement XO019 by GPM  [XO019]

Precision C hubs for XO-1 Slash setups

This two-piece C hub set is a scale replacement manufactured from 6061 T6 aluminium with Delrin collars pressed into the bore to reduce lateral clearance between the hub and the knuckle arms. The collars provide a low-friction mating surface that helps steering geometry hold under load, useful when tuning steering balance on TRAXXAS Slash 4x4 vehicles.

Hubs are supplied as a matched pair and are intended to occupy the same mounting points as the original plastic units; the metal construction improves resistance to wear. Fitters should confirm knuckle and steering link alignment before locking down fasteners and ensure bearings or hardware do not foul the new hubs.

As a tuning upgrade these hubs reduce play in the steering assembly so that input changes in caster and toe map more directly to wheel direction. Note that increased stiffness compared with the stock plastic will alter steering response, so verify alignment and endplay after installation.

If you want a durable metal option to tighten steering feel on compatible Slash 4x4 XO-1 rigs, this GPM 2 pcs C hub set is a simple upgrade; always check fit before final assembly.