Slash 4x4 Front CVD Drive Shaft 12mmx6mm Wheel Hex SSLA1280FH by GPM  [SSLA1280FH]

Front driveline CVD for Slash 4x4

This aftermarket front CVD shaft is built for TRAXXAS 1/10 Slash 4x4 scale trucks. Combining steel and aluminium parts gives strength at stress points while lowering unsprung and rotating mass, and the design is intended only for RC model use. It is supplied to fit typical Slash 4x4 front axle layout without suggesting any full-size vehicle application.

The CVD head and wheel hex received retention-focused revisions versus older parts, and the unit incorporates an adjustable length feature to assist with different suspension and axle layouts. These updates make it a good choice for hobbyists looking for a rugged upgrade that still installs without heavy modification.

Installation tips: the shaft is intended to replace the stock front driveline by sliding into the existing crosspins and hub bores. Confirm pin positioning, torque the hex correctly, and check axle alignment during setup. Use recommended tools and thread locking where needed.

For racers and weekend bashers wanting improved front-end retention and serviceability, this replacement gives a reliable upgrade path for Slash 4x4 setups.