SRB Tail Boom Mount Service Part for SRB Series - HI0302010 by Hirobo  [HI0302010]

HIROBO 0302-010 SRB TAIL BOOM HOLDER #0302010
Price:
NZD$11.00
Brand:
Hirobo
Model:
HI0302010
GTIN:
4512895149987
Condition:
Brand New
Write a review

Product Summary for SRB Holder

The Hirobo HI0302010 tail boom holder is produced for use with SRB tail assemblies on RC helicopters. As a dedicated mount, it locates and retains the tail boom in the correct relation to the main airframe on SRB-series machines.

It is offered as a service or replacement item to be used when the OEM holder is worn or damaged. The holder interfaces with the existing boom and support points to reestablish proper alignment and fit.

Installation notes: align the tail boom before final fastener torque, select the correct hex driver and matching screws, and do not overtighten to avoid stressing nearby mounting features. Correct installation supports reliable tail rotor geometry and control response.

How can I verify this part fits my helicopter?

Compare the HI0302010 part number to your model's spares list and ensure your helicopter uses the SRB tail architecture. If your parts list specifies SRB components, this holder is the intended replacement.

Are original fasteners required?

You can usually reuse the correct-size fasteners if they are undamaged, but replace stripped or corroded screws. Use the same thread type and length recommended by the airframe manufacturer.

Is this a direct swap with the factory part?

Yes, the HI0302010 is intended as a direct replacement for SRB holders. Check fitment and alignment during installation to confirm a seamless swap.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved