SRX8 Gen4 GP Hardcoated Aluminium Rear-Right Shock Mount Compatible with SRX8 Gen4 GP (SER600024) - Serpent 601353 [SER601353]

Serpent SER601353 Shockmount Aluminium hardcoated RR

Price:

NZD$22.49

Brand:

Serpent

Model:

SER601353

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Aluminium hardcoat rear shock mount

This aluminium shock mount carries the Serpent part number 601353 and is specified as the hardcoated rear-right component for SRX8 Gen4 GP (SER600024). It is intended to replace the original mount to prioritise service life and reliable geometry.

Hardcoating on the contact surfaces reduces wear where the shock connects to the chassis and helps maintain alignment under dynamic loads. Because mount stiffness and finish affect shock movement during compression and rebound, treat the mount as an integral element of suspension setup when making tuning changes.

Installation typically involves swapping the RR mount with the like-for-like part on a compatible SRX8 Gen4 GP chassis. Verify with the seller whether mounting hardware is supplied and inspect thread inserts before tightening to avoid damaging the aluminium.

How do I install Serpent 601353 on my SRX8 Gen4 GP?

Remove the existing RR shockmount and fit Serpent 601353 in the same orientation. Confirm the seller’s listing for included fasteners and follow recommended torque practices for aluminium parts.

Should I be concerned about thread inserts when refitting?

Yes. Check the condition of any thread inserts before refitting and avoid over-torquing screws into aluminium to prevent strip-out. Replace inserts if worn or damaged.