SRX8 V2 Rear Mount Bracket - Serpent 601384  [SER601384]

Price:
NZD$45.41
Brand:
Serpent
Model:
SER601384
Condition:
Brand New
Write a review

SRX8 V2 rear mounting bracket overview

The Serpent 601384 suspension bracket serves as a replacement rear link mount for SRX8 V2 platforms. Its design gives a firm attachment point to help control rear roll center and toe characteristics while leaving hub components unchanged.

Fit this bracket when replacing a damaged rear mount or during setup sessions that call for geometry changes. Verify compatibility against the chassis codes listed in the specifications below before fitting.

Specifications

  • Item: Suspension bracket rear RR RR
  • Material: Aluminium
  • Model Number: Serpent 601384
  • Compatibility: SRX8 V2, SRX8 Gen4 GP (SER600024)

Keep original fasteners if serviceable, inspect alignment after installation and adjust rear geometry progressively to find the desired balance.

How durable is the aluminium bracket under regular track sessions?

Anodized aluminium offers good resistance to wear for routine track use, but heavy impacts may still deform the part; inspect after incidents and replace if bent.

Does the finish help resist corrosion and wear?

The anodized surface improves protection against abrasion and environmental exposure, though regular checks and cleaning will extend service life.

If the bracket bends, can it be reused?

Minor bends may be tightened, but for precision geometry it is safer to replace a deformed bracket to maintain consistent handling.

How often should I inspect this part?

Inspect the bracket after any crash and include it in routine setup checks; look for cracks, bends, and fastener wear to avoid unexpected failures.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved