SRX8GTR Front Wishbone Carbon Replacement for SRX8GTR EC GP (SER600077) - Serpent 601403  [SER601403]

Carbon wishbone features for SRX8GTR

The Serpent 601403 carbon front wishbone is supplied as a direct-fit replacement for the SRX8GTR EC GP (SER600077) chassis. As a carbon suspension arm, it influences steering characteristics, camber progression, and chassis roll behavior. It is cut to tight tolerances and intended to support setup changes rather than purely cosmetic updates.

Before you fit it: confirm the part matches your SRX8GTR upper and lower mounting points, check that the hardware you plan to use has compatible thread type and length, and tighten fasteners to the chassis maker's recommended torque. Minor alterations to arm geometry will change scrub radius and camber gain, so integrate this into a comprehensive front-end setup plan.

Durability notes: inspect screw holes and contact surfaces after initial runs and replace any worn hardware. Because carbon can concentrate load at fastener zones, use suitable washers and avoid overtightening to lower fracture risk.

Compatible Models

• Serpent SRX8GTR EC GP (SER600077)

Use this carbon wishbone as part of staged setup work on the SRX8GTR, combining it with verified mounting hardware and small, incremental adjustments to steering geometry and damper settings.