SRX8T Rear Shocktower Upgrade for SRX8T RTR - 601396 Serpent  [SER601396]

Serpent SER601396 Shocktower rr SRX8T RTR
Price:
NZD$0.00
Brand:
Serpent
Model:
SER601396
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Overview of the SRX8T Rear Mount

This replacement shocktower fits the Serpent SRX8T RTR chassis as a rear mounting component for scale truggy applications. The description focuses on fitment, installation reminders, and the tower's effect on suspension geometry without asserting additional technical claims beyond the listed model.

Compatibility is specific to the SRX8T RTR marking in the product title. Prior to installation, confirm fastener hole alignment and upper-link clearance on your chassis so the tower matches the SRX8T shock arrangement. Avoid forcing the part onto incompatible frames unless the mounting pattern is identical.

When installing, remove the rear shocks and body mounts first, support the chassis to avoid geometry shifts while screws are removed, and tighten fasteners to the torque values recommended by Serpent for the SRX8T. After fitting, re-evaluate shock mounting heights, spring preload, and arm angles to recover the intended handling characteristics.

Tuning notes: the tower sets the available upper shock positions and link geometry, which impacts roll center and camber recovery. Use systematic adjustments—move one setting at a time and log changes—to determine their track effect.

What is the best way to test handling after swapping the tower?

Perform short test runs on a familiar surface and note understeer or oversteer tendencies. Change one variable at a time—such as moving to a different upper shock hole—so you can attribute handling differences to a specific adjustment.

Can I use the Serpent 601396 with different shock lengths?

The tower defines mounting heights and will work with shocks that match those heights on the SRX8T layout. Before fitting alternate shocks, confirm they provide the same mounting geometry and travel range to avoid binding or altered handling.

Should I reuse the original hardware when installing this tower?

Reusing original screws and washers is acceptable if they are undamaged and match the hole sizes. If hardware shows wear, replace it with equivalent fasteners and torque to the values in your SRX8T service guide.

How does upper shock placement affect traction with this tower?

Moving the upper shock position alters the shock angle and roll center, which can increase or reduce rear traction depending on surface and setup. Make conservative changes and track results to find the best configuration.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved