SSR-VI Link Arm Stabilizer Replacement - HI0414217 by Hirobo  [HI0414217]

HIROBO 0414-217 SSR-VI STABILZER CONTROL ARM #0414217
Price:
NZD$35.79
Brand:
Hirobo
Model:
HI0414217
GTIN:
4512895129231
Condition:
Brand New
Write a review

What the control arm does

This is a Hirobo replacement control arm built for the SSR-VI stabilizer assembly on RC helicopters. The description highlights the arm's role in setting link geometry and improving tail centring, rather than claiming specifics about material or strength. Use the part to replace worn linkage points or to refine stabilizer movement when adjusting setup.

Specifications

  • Item: Stabilizer Control Arm
  • Material: Not specified
  • Model Number: HI0414217
  • Compatibility: SSR-VI

When renewing or tuning SSR-VI stabilizer geometry, confirm fit before fitting and re-check linkage angles during setup to keep tail behaviour consistent.

Can I swap this into any SSR-VI stabilizer assembly?

The arm is specified for SSR-VI; check that the mounting points and hole centres align with your aircraft before installing.

Does this part improve longevity or just restore geometry?

This item is described as a replacement for restoring correct geometry; the listing does not make explicit claims about increased lifespan or material upgrades.

Should other components be replaced at the same time?

Inspect ball links, screws and mounting hardware for wear; replacing worn connection points at the same time helps ensure reliable fit and function.

How do I verify stabilizer behaviour after fitting?

Power down the model and cycle controls to check for smooth movement and no binding, then confirm the stabilizer sits neutral before attempting a flight.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved