Yokomo B10-302SA Rear Stiffener for BD10 and BD11  [B10-302SA]

Yokomo B10-302SA Steel rear stiffner for BD10
Price:
NZD$36.37
Brand:
Yokomo
Model:
B10-302SA
GTIN:
0639342202591
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MRTC-BD10FF category
Write a review

Steel rear plate for BD10/BD11 chassis

The Yokomo B10-302SA serves as an aftermarket steel rear stiffener for 1/10 touring chassis, designed to alter rear flex and balance by changing mounting points and the number of screws used. Because it is steel rather than aluminium, the piece adds mass and can be used purposefully as ballast to influence handling.

Fitted as a scale upgrade, the plate changes how the rear end responds to load and steering inputs. Try different mounting configurations to dial in rear traction, transient rotation, and the trade off between stability and responsiveness.

Specifications

  • Item: Rear stiffener
  • Material: Steel
  • Model Number: B10-302SA
  • Compatibility: MRTC-BD10, MRTC-BD10A, MRTC-BD10FF, MRTC-BD10LC, MRTC-BD10LCA, MRTC-BD10LCR, MRTC-BD10LCRA, MRTC-BD11-1, MSR-BD11, MRTC-BD11US, MRTC-BD11A-1, MSR-010FE, MSR-010FEA

Compatible Models

  • MRTC-BD10
  • MRTC-BD10A
  • MRTC-BD10FF
  • MRTC-BD10LC
  • MRTC-BD10LCA
  • MRTC-BD10LCR
  • MRTC-BD10LCRA
  • MRTC-BD11-1
  • MSR-BD11
  • MRTC-BD11US
  • MRTC-BD11A-1
  • MSR-010FE
  • MSR-010FEA

Select this steel stiffener when you want increased rear stiffness range and the option to add rear-end ballast during setup testing on BD10/BD11-derived cars.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is steel likely to corrode on road or humid tracks?

Steel can corrode if exposed to moisture or salt. Wipe the stiffener dry after wet runs, inspect mounting areas, and consider a protective coating or anti-corrosion treatment if you run in damp conditions.

Will repeated stress cause fatigue or bending?

Steel is tougher than thin aluminium but can still deform under severe impact. Inspect for bends or cracks after heavy contact; replace if the part shows permanent deformation.

Can I add a surface finish to prevent rust?

Yes. Light protective finishes such as clear lacquer or corrosion inhibitors help preserve the surface. Apply carefully to avoid affecting fit where the stiffener mates to the chassis.

How should I check mounting after several sessions?

Look for loose or rusted fasteners, uneven wear at contact points, and any movement at the mount. Tighten progressively and replace fasteners showing corrosion or thread damage.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved