Steering Bellcrank B Compatible with DIB - Yokomo YOKIB202BR (Red)  [YOKIB202BR]

Yokomo IB202BR - Steering Bellcrank B for DIB/Red
Price:
NZD$32.91
Brand:
Yokomo
Model:
YOKIB202BR
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DIB category
Write a review

DIB-compatible bellcrank B spare

The Yokomo YOKIB202BR is supplied as a steering bellcrank B for DIB-compatible chassis and is sold as a spare component for the steering linkage. It carries the model designation and red finish referenced in the title and is used where the original part's geometry matches the replacement.

Installation follows typical RC repair steps: remove the servo horn and linkage, loosen the fasteners holding the old bellcrank, replace with the YOKIB202BR assembly, and tighten while ensuring symmetric travel. Use the correct sized hex tool and confirm there is no binding at either lock; final transmitter setup should include centring and endpoint checks.

This bellcrank functions as a service item affecting linkage geometry and steering consistency rather than delivering measurable performance upgrades. Replace worn or damaged bellcranks to maintain repeatable steering behaviour and then fine-tune link lengths and centring for best results.

Specifications

  • Item: Steering bellcrank B
  • Material: unspecified
  • Model Number: YOKIB202BR
  • Compatibility: for DIB

Fit the YOKIB202BR only where the DIB bellcrank geometry matches; always check fitment before final torqueing and verify steering alignment after installation.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this bellcrank hold up to regular club use?

The listing does not specify material, so durability depends on production finish and usage. Inspect the item for wear after hard use and consider replacing if play develops.

Is the finish corrosion resistant?

Finish details are not provided in the specification. If corrosion resistance matters, check the seller notes or request photos of the coating before purchase.

Can I reuse existing linkages with this part?

Yes, reuse is common if the linkage ball studs and spacing align. Verify the pivot spacing and ball stud positions match the replacement to avoid geometry changes.

Should I check anything before fitting?

Confirm mounting hole alignment and ensure the servo horn and linkage lengths are compatible; trial-fit before applying final torque to fasteners.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved