Steering Tie Rod Upgrade for Axial Yeti - Aluminum YT-25009-B by Jazrider  [YT-25009-B]

Axial Racing Yeti Aluminum Steering Tie Rod
Price:
NZD$16.76
Brand:
JAZRIDER
Model:
YT-25009-B
Condition:
Brand New
Available in shop
Write a review

Tie rod for Axial Yeti explained

This RC-scale steering tie rod is made for Axial Yeti chassis applications and carries the model number YT-25009-B. Machined from aluminum, the component aims to reduce linkage compliance and deliver a firmer transfer of servo motion to the wheel knuckles.

When fitting, use the tie rod to set toe and centre the steering. Verify compatibility with your current rod ends and ball studs, check thread engagement, and ensure free movement through the steering travel with no binding at the knuckles or mounts. Intended for hobby off-road RC use only.

Tuning tip: replacing a flexible or aged tie rod with a rigid aluminum part can stabilise steering geometry under heavy load, although final response will depend on servo choice, mount position and overall linkage angles.

How do I confirm fit before installation?

Measure your existing rod end spacing and compare thread sizes. Make sure the rod ends and ball studs match or can be swapped to achieve correct geometry.

What should I watch for at full lock?

Check for any contact between the rod and chassis parts, and ensure threads remain engaged with enough clearance at both steering extremes.

Is special hardware needed?

Typically you can use your existing rod ends if sizes match; otherwise swap to compatible rod ends or spacers. No specialised tools beyond common hex drivers should be required.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved