Serpent 401513 S411 FF Precision Steering Rack  [SER401513]

Serpent SER401513 Steeringrack 411-FF
Price:
NZD$49.17
Brand:
Serpent
Model:
SER401513
Condition:
Brand New
Write a review

Precision Steering Part for S411 FF Chassis

The Serpent 401513 is the OEM steering rack designed to keep an S411 FF 1/10 EP 2WD steering system tight and responsive. It is produced to match the S411 FF steering geometry, restoring accurate wheel control after wear or minor damage. Racers looking to maintain consistent lap times will value the renewed steering feel this spare provides.

Rugged Construction for Regular Running

Made to withstand repeated track sessions, the Serpent 401513 steering rack resists deformation and helps maintain alignment under load. Its dependable build reduces steering slack and helps you hold clean lines through sections where precise inputs matter most. Periodic checks will extend its service life.

Is the Serpent 401513 a direct bolt-in for the S411 FF?

Yes, the 401513 steering rack is made as a direct replacement for the S411 FF 1/10 EP 2WD and should install without custom work on a standard chassis.

Will this affect my servo setup?

The part is compatible with the steering geometry used on the S411 FF; you should check linkage lengths and horn position after fitting but no major servo changes are normally required.

How do I spot wear on the steering rack?

Look for excessive play in the steering linkage, uneven toe settings after setup, or visible damage to the rack teeth or mounting points as signs that replacement is needed.

Should I inspect anything after a crash?

After an impact, check the rack and tie rods for bends or looseness and verify steering geometry before running to avoid unpredictable handling.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved