Super X Compatible Rear Roll Stay Carbon 1.5mm - Tamiya 95716 Jr HG  [95716]

Tamiya 95716 Jr HG carbon rear roll stay compatible with Super X chassis

The Tamiya 95716 Jr HG Carbon Rear Roll Stay is a 1.5mm carbon fibre rear stay supplied as a service or replacement item for Mini 4WD models using the Super X chassis pattern. It is categorised as a spare part for builders checking fit and durability.

Fabricated from a 1.5mm carbon sheet, this stay provides a stiff mounting face for rear rollers while keeping the profile slim. It is aimed at hobbyists who want a direct-fit carbon stay for Jr HG sized components on Super X builds, prioritising material properties and fit over cosmetic detailing.

Installation uses the usual Super X rear stay screws and spacers; care is needed when torquing to avoid crushing the laminate. Builders will appreciate that 1.5mm carbon gives a solid feel with a small amount of compliance; use suitable shims and washers to protect hole rims and manage plate compression.

Before use, inspect the mounting holes for any signs of delamination and check roller alignment against the rear bumper and plates. Trim or lightly file edges to remove any splinters but avoid changing hole positions unless you plan to ream and reinforce them for alternate screw sizes.

A practical carbon rear roll stay intended for Super X layout replacements; use it to swap out worn plastic stays while keeping the stock mounting geometry.