SVi extension lead for receivers - Futaba FUEBB0154 200mm 30-strand  [FUEBB0154]

Overview of the Futaba SVi extension

This Futaba i-Connector lead serves as a direct connection from an SVi port to a receiver channel, providing 200mm of cable length and a 30-strand conductor set. It is supplied as a wiring accessory to aid neat routing and to preserve the SVi signal path while extending reach for device placement.

To fit, insert the i-Connector into the SVi output, route the cable to the receiver, then plug the receiver end into the chosen channel. Keep the cable tidy with light ties or tape to avoid snagging during adjustments and test runs.

For bench checks and tuning the extension makes it easier to access channels and swap or test servos without disturbing the main harness routing. It supports organised wiring during setup and adjustments.