Swing Wheel Arms for Tamiya 56020 1/16 Leopard 2A6 — Alloy Replacement JR-T2A601-S by Jazrider  [JR-T2A601-S]

Jazrider Aluminum Swing Wheel Arms (2pcs) for Tamiya 56020 1/16 Leopard 2A6 Tank
Price:
NZD$11.90
Brand:
JAZRIDER
Model:
JR-T2A601-S
Condition:
Brand New
Available in shop
Write a review
alt="Jazrider Aluminum Swing Wheel Arms (2pcs) for Tamiya 56020 1/16 Leopard 2A6 Tank" title="Jazrider Aluminum Swing Wheel Arms (2pcs) for Tamiya 56020 1/16 Leopard 2A6 Tank"

Heavy-duty alloy swing arms for Leopard 2A6

This listing covers a set of 2pcs aluminum swing wheel arms intended for 1/16 scale RC tanks, specifically for the Tamiya 56020 1/16 Leopard 2A6. They serve as direct replacements for the chassis swing wheel assemblies, useful for maintenance and drivetrain tuning tasks.

Manufactured from alloyed aluminum, these arms offer higher stiffness than stock plastic components and are supplied as a matched pair to preserve balance across the running gear. Fit them when wear or chassis upgrades demand a firmer mounting point.

Installation guidance: check clearances on the 56020 chassis before locking hardware, inspect retaining pins and bearings for serviceability, and cycle the suspension through full travel to confirm no interference. For RC tank use only.

Are these stronger than the original plastic arms?

Yes, the alloy construction increases stiffness and resistance to deformation compared with common plastic swing arms used on stock units.

Can I reuse existing bearings and pins?

You can reuse bearings and pins if they are within tolerance; inspect them closely and replace any worn items to ensure correct fitment.

Do these need any special machining to fit?

These are produced for direct-fit replacement but you should verify alignment and may need minor trimming of adhesive or burrs on older chassis components.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved