T3'12 XRAY Front Shock Tower 3.0MM Graphite Upgrade - Arrowmax AM-T3-303086  [AM-T3-303086]

Front Shock Tower, 3.0MM Graphite for T3'12

This is a front shock tower suited to the T3'12 front end and identified by Arrowmax part AM-T3-303086. Cut from 3.0MM graphite sheet, the tower fixes the front shock mounting points so you can reliably adjust shock angle, preload position, and roll-center geometry during setup sessions.

Installation follows the stock front end procedure: remove the existing tower, place this unit over the original mounting holes, and use the chassis screws and shock mounting hardware supplied with your kit. No specialised tools are necessary; typical hex drivers and hand tools are sufficient, and the part is compatible with common shock assemblies used on the chassis.

For tuning, this tower is a consistent baseline for front suspension geometry. Changing the tower thickness or moving shock positions changes leverage and response, so try adjustments step-by-step and note handling differences on the circuit.