T9C/T10C DSC Cable (Square Plug) - Futaba FU6A14601  [FU6A14601]

FUTABA DSC CABLE CORD SQUARE PLUG FOR T9C T10C RADIO TRANSMITTER SETUP 6A14601 (W/O PACKING)
Price:
NZD$11.17
Brand:
Futaba
Model:
FU6A14601
Condition:
Brand New
Write a review

Square-plug DSC lead for T9C and T10C radios

This is a DSC cable assembly fitted with a square plug intended for Futaba T9C and T10C transmitters. It is an RC transmitter spare intended to replace factory wiring that uses the DSC connector and is provided without retail packing.

Use the lead to restore a lost or damaged DSC connection, or when reorganising internal cables during service. Its purpose is reliable connector engagement and tidy cable routing rather than altering transmitter behavior.

Installation tips: power down the transmitter before connecting or disconnecting the lead, ensure the square plug is fully seated in the DSC socket, and secure exposed wiring to reduce strain on the connector. After installation, power up and verify normal link to any attached modules.

Tuning note: the cable will not change radio settings, but keeping the DSC link secure helps ensure stable communication with peripherals such as telemetry units and external modules, simplifying setup checks.

Can this lead be used with other Futaba models that share the DSC connector?

The item is specified for T9C and T10C transmitters. If another model uses the identical DSC square plug, it may be compatible, but confirm connector shape and pin layout before use.

Is any special handling required when routing this cable?

No special handling beyond standard cable management. Avoid sharp bends, secure the cable to prevent movement, and take care not to tug on the connector when routing.

Does fitting this cord require calibration afterward?

Fitting the cord does not require calibration. Once correctly installed and connected, the transmitter should operate as before; the cord simply maintains the DSC link for accessories.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved