TA01 and TA02 Rear Shock Tower, Aluminium Blue - JAZRIDER JR-TA105-DB  [JR-TA105-DB]

Rear shock tower, aluminium fit for TA01/TA02

This aluminium rear shock tower from JAZRIDER is an aftermarket component made to work with Tamiya TA01 and TA02 chassis patterns. As the upper anchor for rear shocks and linkages it helps preserve shock geometry under load and when adjusting setups.

Role in tuning: fitted as the shock top mount, the tower affects rear roll resistance and the perceived damping response when using different mounting holes or shock orientations. Drivers choose aluminium towers to reduce flex and maintain consistent adjustment points versus stock plastic parts.

Fit and compatibility: the item is aimed at Tamiya TA01 and TA02 layouts and follows the same mounting spacing those chassis use. As an aftermarket part, confirm hole alignment and retain original fasteners where they match the thread and head clearance.

Installation guidance: support the chassis and relieve shock preload before swapping the plate, torque screws to recommended levels to avoid stripping, and recheck fastener tightness after a short break-in run.