Tail Mixing Link for EMBLA SZM2 - HI0304113 Hirobo  [HI0304113]

Function and fit for EMBLA SZM2 tail

This mixing arm (HI0304113) is supplied for the EMBLA SZM2 and acts as the critical link that translates servo signals into combined tail movement for heading control.

Use it to replace worn or broken arms to bring back correct tail mixing and trim characteristics. Focus on confirming the part's fit with your model's linkage geometry before committing to flight.

Installation guidance: detach the faulty linkage, line up the replacement to match existing geometry, and tighten fixings following the same torque and safety practices used on EMBLA SZM2 setups. After installation, perform a low-power hover test to verify correct tail direction and make trim adjustments.

Care advice: periodically check pivot play and fastener tightness, and change any degraded connectors to retain consistent tail control.