Tamiya 0000002 TB Evo Lightweight Bevel Pinion Gear Tweak  [0000002]

Price:
NZD$6.57
Brand:
Tamiya
Model:
0000002
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine Tune Your TB Evo Setup

If you are tuning a TB Evolution chassis, the Tamiya 0000002 Lightweight Bevel Pinion Gear is a neat upgrade to trim inertia and improve responsiveness. Built for TB Evo models, this lighter pinion helps the drivetrain react quicker when you apply power out of corners.

Handling and Acceleration Gains

Manufactured to balance resilience with low mass, the Tamiya bevel pinion reduces rotating weight without sacrificing durability. The result is crisper acceleration and a more responsive steering feel during tight pack or club racing.

Is Tamiya 0000002 a direct replacement for stock pinions?

In most TB Evo builds it is a direct swap, but always check the shaft fit and clearance before running to avoid binding.

Will this change my gearing feel?

The lighter pinion reduces rotating mass, which improves response; it does not alter the gear ratio unless you change tooth counts.

Any tips for installation on a TB Evo?

Fit the pinion with correct mesh, secure the set screw, and spin the drivetrain by hand to confirm smooth engagement before powering up.

How do I tell when the pinion needs replacing?

Look for worn or rounded teeth, uneven wear patterns, or noise under load; any of these indicate it is time for a replacement.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved