Tamiya 10325 HG Replacement Needle 0.3 for Spray Works 74532/74537 - Fine-detail needle for model painters [10325]

Price:

NZD$23.78

Brand:

Tamiya

Model:

10325

GTIN:

4950344103256

Condition:

Brand New

Quantity:

Available in warehouse

Write a review

Description
FAQ

Restore fine lines with the Tamiya 10325 HG Replacement Needle

Keep your Tamiya airbrush performing at its best by fitting the Tamiya 10325 HG Replacement Needle. The 0.3 tip helps you maintain consistent, sharp sprays for scale work and touchups.

Compatibility and fit notes

The needle is intended for the Tamiya Spray Work HG Airbrush III (Item 74532) and the Spray-Work HG Airbrush with Integrated Cup (Item 74537). It replaces worn or bent needles to bring back accurate spray control.

What is included

One HG airbrush needle
Protective tube for secure storage

Can I use this needle with non-Tamiya airbrushes?

This needle is tailored for the Spray Work HG series. Other brands may not match the needle length or taper, so compatibility is not guaranteed.

Steps to replace the needle safely?

Remove paint and pressure, unscrew the nozzle, pull the old needle straight out, insert the new needle gently until it seats, then tighten per the manual.

How do I avoid bending the needle?

Handle the needle by the blunt end, avoid pushing against the nozzle, and always move it straight in or out. Use the protective tube for storage.

Is the 0.3 size good for primer and detail?

Yes, 0.3 offers a balance for light priming and fine detailing. Tune pressure and paint mix for even flow and minimal overspray.

Hot Brands