Tamiya 1/14 King Hauler / Ford Aeromax 153mm Alloy Main Drive Shaft TRU153 by GPM  [TRU153]

Tamiya 1/14 Truck King Hauler /Ford Aeromax Alloy Main Drive Shaft (153mm) - 1pc - GPM TRU153
Price:
NZD$22.02
Brand:
GPM
Model:
TRU153
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Design and compatibility

This 153mm alloy main drive shaft is produced for compatibility with Tamiya 1/14 Truck King Hauler and Ford Aeromax, supplied as 1 pcs. It serves as a direct replacement for the stock shaft to improve drivetrain durability in scale tractor-truck builds and setup tweaks.

Compatibility is limited to the listed Tamiya 1/14 platforms; always confirm gearbox spline count and shaft seating dimensions before fitting. As an aftermarket alloy part, the shaft is intended to use the model's original couplings, bearings, and retaining hardware.

Fitting advice: brace the gearbox when removing the old shaft to avoid misalignment, recheck pinion and spur engagement after installation, and ensure minimal runout. Regular maintenance should include spline inspection and lubrication of contact points to prolong service life. This product is for hobby RC applications only.

Is this a straightforward swap on the 1/14 Tamiya trucks?

Yes, where the original shaft matches the 153mm length and spline pattern this is a direct aftermarket replacement, but always double check the spline count and seating before ordering.

Do I need new bearings or couplers?

The shaft is designed to integrate with the truck's existing bearings and couplers in most cases; only replace hardware if you find wear or fitment issues during installation.

What routine checks are recommended?

Periodically check spline engagement and surrounding bearings, keep contact points clean and lightly lubricated, and monitor for any unusual vibration or play.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved