Off-road ready shaft set - Tamiya 22054 - 37mm Drive Shafts for Double Cardan Joint (2pcs) OP-2054  [22054]

Tamiya 22054 - 37mm Drive Shafts for Double Cardan Joint Shafts (2pcs) OP-2054
Price:
NZD$24.10
Brand:
Tamiya
Model:
22054
GTIN:
4950344220540
Condition:
Brand New
Available in warehouse
Write a review

Refine XV-02 performance with 37mm double cardan shafts

The Tamiya 22054 - 37mm Drive Shafts for Double Cardan Joint (2pcs) OP-2054 are built to improve driveline articulation on the XV-02 chassis. The dual joint design allows smoother rotation through large steering and suspension angles, helping to protect linked parts and maintain steady drive under load.

Compatibility and pairing advice

These 37mm assemblies are intended for XV-02 use and work well alongside common Hop-Up parts. They follow standard 37mm universal shaft sizing to ease replacement and allow quick pairing with matching bearings and joint casings.

  • Item 42218: Axle Shaft for Double Cardan Joint Shaft (2pcs.)
  • Item 42219: Joint Casing for Double Cardan Joint Shaft (2pcs.)
  • Item 42220: 1050 Ball Bearing (3mm Thick, 2pcs.)
  • Item 42221: Cross Joint for Double Cardan Joint Shaft (2pcs.)
If your axle spacing or shaft length has been altered, measure clearance and spline engagement first. The 37mm shaft length is fixed, so custom axle work may be required for extended setups.
Yes, by reducing binding at joint angles they tend to lower clunking and chatter, making the drive quieter and smoother, especially under steering loads.
Rinse off grit, dry thoroughly, relube the joints and check the 1050 bearings and cross joints for play. Replace any pitted or damaged components promptly.
Cross joints such as Item 42221 are sold as replacement parts; keep spares on hand if you run hard or tackle rough tracks.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved