Tamiya 2595024 Long Propeller Joint for Porsche 959 58059 4WD Spare Part  [2595024]

Tamiya 2595024 - Porsche 959 Long Propeller Joint for 58059 4WD Raclly Car
Price:
NZD$16.47
Brand:
Tamiya
Model:
2595024
Condition:
Brand New
Write a review

Restore Smooth Drive on Your Porsche 959

The Tamiya 2595024 long propeller joint is an essential spare for owners of the Porsche 959 4WD RC rally car. It provides consistent power transfer and helps the model stay composed over rough tracks and road sections.

Model Matching and Use

Built with the Tamiya 58059 Porsche 959 layout in mind, this propeller joint fits the 4WD drive architecture and is suitable for standard replacement tasks. Confirm fitment by comparing spline and shaft sizes before installation.

Practical Fitting Advice

Installation is straightforward with common hobby tools; ensure couplings are seated and fasteners torqued to specification. Regular checks prevent premature wear and keep handling predictable during club runs.

Can I use this joint in modified drive setups?

If modifications kept the original shaft and spline dimensions, it may fit, but any change to shaft length or spline count can prevent proper installation. Measure before swapping.

How often should the joint be checked?

Check the joint after heavy sessions or if you run on rough terrain frequently. A quick visual and manual rotation check after each outing is a good routine.

Are special tools required to replace it?

Most hobbyists can replace the joint using standard hex drivers and pliers. A small punch and light grease will help seat the part and protect metal-on-metal areas.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved