Tamiya 3455769 TB Evo 4 Spur Gear Support Plate  [3455769]

Tamiya 3455769 - TB Evo 4 / IV Spur Gear Mount / Holder (For 58331)
Price:
NZD$20.12
Brand:
Tamiya
Model:
3455769
Condition:
Brand New
Write a review

Compact Spur Gear Support for TB Evo IV

The Tamiya 3455769 Spur Gear Mount Holder is designed for enthusiasts running the TB Evo IV. It provides a compact support point for the spur gear to keep the drive components running true under load.

Where It Fits

Made to suit the TB Evo IV, this holder pairs well with Tamiya part 58331. It creates a steady seating for the spur gear, helping to cut down on lateral play and uneven wear.

Installation Notes for Hobbyists

Installation is user friendly and uses the chassis mounting holes provided. No cutting or special adapters are normally required so you can fit it during a regular build or service session.

Can I use aftermarket spur gears with this mount?

Aftermarket spurs that match the TB Evo IV spacing should be fine, but check tooth count and thickness to ensure proper mesh and clearance.

Will it change gear mesh settings?

The mount keeps the spur steady but you should still set pinion to spur mesh as usual to avoid binding or excess wear.

Is it made from durable material?

The holder is built for regular RC use; inspect it periodically and replace if you notice cracks or deformation after heavy running.

Does it affect centre diff alignment?

When installed correctly it should not disturb differential alignment, but confirm driveline angles during setup and test runs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved