Tamiya 3485258 Tractor Truck 5x33mm Drive Shaft  [3485258]

Price:
NZD$0.00
Brand:
Tamiya
Model:
3485258
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Spare 5x33mm Shaft for Tamiya Truck Builds

The Tamiya 3485258 5x33mm shaft is intended for use in Tamiya tractor truck assemblies where a robust, precision shaft is required. It is a practical choice for model owners replacing a worn component or stocking essential spares.

Steel Strength and Chassis Compatibility

Forged from durable steel, the Tamiya 3485258 resists deformation and keeps its dimensions under load. It is compatible with TA-01 and TA-02 chassis layouts, offering a reliable renewal part for those platforms.

Maintenance and Minor Upgrades

As a direct replacement part, this shaft helps maintain correct driveline geometry and can slightly improve rotational stability when replacing damaged originals. Ideal for routine maintenance plans.

Will this fit my TA-02 truck without modification?

Yes, the Tamiya 3485258 is manufactured to fit TA-02 and TA-01 chassis types and should replace the original shaft without parts changes.

What routine checks should I perform after fitting?

After installation, check alignment, bearing play, and set screws. Run the model at low speed first to confirm there is no binding or unusual noise.

Is any special lubrication required?

Use a light machine grease on mating surfaces and keep bearings clean. Avoid heavy greases that attract grit and increase wear.

Can I reuse existing hardware when swapping the shaft?

If set screws and collars are undamaged, they can be reused, but inspect them for wear and replace if there is rounding or thread damage.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved