Tamiya 40559 GB-03 Rear Carbon Damper Stay for GB03 TT-Gear  [40559]

Tamiya 40559 - RC GB-03 Carbon Damper Stay - Rear - For GB03 TT-Gear
Price:
NZD$23.23
Brand:
Tamiya
Model:
40559
Condition:
Brand New
Write a review

Adjust Rear Shock Geometry with the GB-03 Carbon Stay

The Tamiya 40559 GB-03 Carbon Damper Stay is a direct carbon fibre upgrade for racers wanting crisper rear-end behaviour on the GB03 TT-Gear chassis. It helps deliver a firmer rear platform that can improve corner consistency when set up correctly.

What the Carbon Damper Stay Offers

Built from 2.5mm carbon fibre, this rear damper stay keeps weight low while providing robust support. The eight damper attachment points let you vary shock leverage and roll centre characteristics for different surfaces and driving preferences. These adjustments are handy for fine-tuning handling balance.

Installation Notes and Compatibility

Fitting the Tamiya GB-03 Carbon Damper Stay is simple with basic hand tools. It is designed with the GB03 TT-Gear in mind, so verify compatibility if you intend to use it on other frames to ensure correct fit and safe operation.

How does changing mounting points affect handling?

Altering where the damper mounts changes shock leverage, which affects roll rate and how the rear responds under acceleration and cornering. Small moves can shift traction and rotation.

Is special hardware needed to fit this part?

No special tools are required; typical RC screwdrivers and hex drivers are enough. Keep the supplied screws and check torque so the carbon plate is held securely without over-tightening.

Will the carbon plate change ride height?

The plate itself does not alter ride height, but changing damper positions can affect suspension geometry and how the car sits under load, so re-evaluate setup after adjustments.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved