Tamiya 4304097 Rear Damper Stay TRF416 Performance Part  [4304097]

Tamiya 4304097 - Rear Damper Stay for 42106
Price:
NZD$21.68
Brand:
Tamiya
Model:
4304097
Condition:
Brand New
Write a review

Enhance TRF416 Rear Suspension

The Tamiya 4304097 Rear Damper Stay is designed for the TRF416 chassis to improve rear suspension consistency. By reducing unwanted movement it gives a steadier platform for tuning shock and roll centre settings. Built with precision, it helps maintain chassis balance during fast runs.

Where It Fits

This rear damper stay is matched to the TRF416 series and fits without any trimming or changes. It is useful as a service replacement or as part of a refinement package for drivers chasing cleaner handling.

Installation Advice

Secure all fasteners evenly when installing the Tamiya Rear Damper Stay and recheck after the first session. Keep an eye on the damper mounts and mounting screws for signs of loosening or wear.

Can I swap this into older TRF variants?

It is engineered for TRF416 geometry; older variants may need checks for alignment. Compare mounting hole positions before swapping parts.

Will this affect shock tuning?

Yes, a stiffer rear platform can change how shock settings behave, so expect to make small adjustments to rebound and damping after fitting.

Is special hardware needed?

Standard mounting screws used on the TRF416 are normally suitable. If screws are worn replace with correct thread and length to maintain a secure fit.

How often should I check it?

Check the stay and surrounding mounts after every few race sessions and after any heavy impacts to prevent unexpected failures on track.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved