Tamiya 4305517 Steering Upgrade Plate TB Evo III Edition  [4305517]

Tamiya 4305517 - Steering Plate for 58299
Price:
NZD$18.26
Brand:
Tamiya
Model:
4305517
Condition:
Brand New
Write a review

Steering Upgrade for TB Evo III

The Tamiya 4305517 steering plate is built to fit the TB Evo III chassis and improve steering consistency. Its tighter interface reduces play for a steadier front end at speed.

Model Compatibility

This component is intended for the Tamiya TB Evo III series and swaps directly with the original plate on compatible builds. It is a practical choice for hobbyists wanting more predictable handling through bends.

Installation Notes

Fit the Tamiya 4305517 with care, ensuring screws are snug but not over tightened. Recheck the mounting after a short run to confirm nothing has worked loose, which can affect steering accuracy.

Can I use this plate with modified suspension arms?

In most cases the 4305517 works with standard TB Evo III arms. If arms are heavily modified you should verify clearances and mounting alignment before final assembly.

Does it require any extra parts to fit?

The plate is a direct replacement and normally uses existing hardware. Keep original screws and check for thread wear before reinstalling.

How often should I inspect this part?

Inspect the plate and mounting screws after every few runs, especially if you race or run off-road. Regular checks help maintain steering performance.

Will this make the car oversteer more?

The plate sharpens steering feel but will not directly cause oversteer. Balance front and rear setup to control handling tendencies.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved