Tamiya 50556 - TA02 Rear Suspension Arm K Part - Precision Fit [50556]

Tamiya 50556 - TA02 Rear Suspension Arm K Part SP-556

Price:

NZD$12.50

Brand:

Tamiya

Model:

50556

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - TA-01 / TA-02

Tight-Fit Rear Arms for TA02 Chassis

The Tamiya 50556 Rear Suspension Arm is made to restore and refine the TA02 chassis behaviour, helping the car track truer through corners. As a Tamiya-made spare, it offers consistent fitment and a sturdy feel for everyday hobby use.

Important Benefits of the Tamiya 50556 Arm

Compatibility: Made to match the TA02 mounting layout for correct geometry.
Durability: Built from resilient materials to tolerate rough runs.
Handling: Reduces flex and helps maintain rear traction and steering response.

Advantages of Fitting a New Arm

Swapping in a fresh suspension arm can correct sloppy handling and help you dial in suspension settings. The Tamiya 50556 Rear Suspension Arm is a straightforward replacement that supports consistent setup changes and longer service intervals.

Can I use this arm with upgraded hubs?

Generally yes, but verify that upgraded hubs keep the same hinge pin spacing and clearances to avoid binding when using the Tamiya 50556 arm.

Is installation difficult for beginners?

Installation is straightforward: remove old arms, check hinge pins and bearings, then fit the new arm. Basic tools and a little patience are usually enough.

What maintenance keeps these arms lasting?

Keep pivot points clean and lightly lubricated, inspect for stress marks after incidents, and replace arms that show any distortion to protect suspension geometry.