Tamiya 50594 - 2x10mm Shaft for RC Car SP-594 Service Grade Steel Shaft [50594]

Tamiya 50594 - Shaft 2x10mm 81/49/62 SP-594

Price:

NZD$5.66

Brand:

Tamiya

Model:

50594

GTIN:

4950344505944

Condition:

Brand New

Quantity:

Available in shop

Write a review

Description
FAQ

Service Grade 2x10mm Shafts

The Tamiya 50594 - 2x10mm Shaft for RC Car SP-594 offers a neat steel replacement for a variety of RC components. Machined and polished, these shafts provide consistent diameter and length for dependable alignment in small mechanisms. They are a practical spare for workshops and raceday toolkits.

Compatibility Notes

These shafts follow the common 2mm x 10mm sizing used across many models and brands, so they often fit without alteration. They work well in linkages, small axle points and where precision shafting is required, making them a straightforward swap during repairs.

Can I use these shafts on older kits with worn components?

Yes, they can replace worn 2x10mm shafts in older kits, but check mating parts for excess wear first. If bearings or housings are loose, replacing only the shaft might not fully restore performance.

Are these shafts corrosion resistant?

The shafts are polished steel which offers basic resistance, but for frequent wet use consider light rust prevention such as oil or protective spray to extend service life.