Tamiya 50965 - TL-01LA Rear Upright Track-Ready Spare  [50965]

Tamiya 50965 - TL-01LA Rear Upright SP-965
Price:
NZD$10.29
Brand:
Tamiya
Model:
50965
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Preparing the TL-01LA with a New Rear Upright

The Tamiya 50965 - TL-01LA Rear Upright is manufactured to fit the TL-01LA chassis and optimise rear-end behaviour. Its design focuses on steady handling and reduced movement under load, helping the car stay composed through mid and high-speed corners.

What the Upright Improves

This replacement part offers a good compromise between rigidity and mass, which helps preserve suspension geometry during aggressive driving. Users will notice steadier rear tracking and improved control when exiting corners or when pushing for lap time.

Quick Installation Advice

  • Tighten screws to the recommended torque and double-check thread engagement.
  • After installation, run a brief test to check toe and camber remain consistent.
  • Monitor the upright for signs of wear after repeated hard use on abrasive surfaces.

Can I use this with aftermarket hubs?

Some aftermarket hubs will work, but you should compare mounting dimensions and test fit before final assembly to avoid misalignment.

Will it change ride height?

The upright itself does not alter ride height, but small differences in hub or spacer thickness can affect overall clearance, so check after fitting.

How often should I inspect it?

Inspect before and after intense sessions or any crash; look for cracks around the mounting points and ensure bearing seats remain true.

Is any special tool needed to fit it?

Standard RC tools are sufficient: small hex drivers, a torque-limited driver if available, and a set of feeler gauges for alignment checks.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved