Tamiya 50983 TB Evo3 Suspension Mount D Setup Part for TB Evo III  [50983]

Tamiya 50983 - TB Evo3 Suspension Mount (D) SP-983
Price:
NZD$18.69
Brand:
Tamiya
Model:
50983
Condition:
Brand New
Write a review

Tweak Suspension Response with Tamiya 50983 TB Evo3 Suspension Mount D

For tuners wanting clearer feedback from their chassis, the Tamiya 50983 TB Evo3 Suspension Mount D offers a practical upgrade. It is intended to work with the TB Evo III platform to help improve handling predictability.

Use Cases for Club and Practice

The Tamiya 50983 suspension mount is a good match for hobbyists who run regular practice sessions and need consistent vehicle behaviour. It supports steady handling across different track conditions.

Installation and Compatibility Advice

Designed to pair with TB Evo III setups, this mount installs into common TB Evo III configurations. It is a simple way to refine suspension without complex chassis changes.

Can I use the mount on a modified TB Evo III

Minor chassis modifications may still allow fitment, but verify mounting holes and clearances on your specific car before fitting the part.

Will it require different shocks or springs

Often stock dampers and springs work, though you may want to adjust spring rates or damper tune to match the changed geometry for best performance.

Is any special tooling needed to fit this part

Basic RC tools like hex drivers and pliers should be sufficient. Refer to your chassis manual to follow correct mounting torque and alignment steps.

How soon can I test after fitting the mount

Once mounted and settings checked, run a few short shakedown runs to assess handling before committing to full sessions or race setups.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved