Tamiya 51118 TG10-Mk.2 Steering Arm K Parts Replacement  [51118]

Tamiya 51118 - TG10-Mk.2 K Parts (Steering Arm) SP-1118
Price:
NZD$11.54
Brand:
Tamiya
Model:
51118
Condition:
Brand New
Write a review

Steering Arm Upgrade for TG10-Mk.2

The Tamiya 51118 - TG10-Mk.2 K Parts (Steering Arm) is a purpose-made spare that helps maintain the original steering geometry of your TG10-Mk.2. It supports accurate wheel direction and solid feedback during both practice and racing.

Benefits for Tracking and Cornering

Replacing ageing steering hardware with a new Tamiya 51118 reduces slop and improves response, letting you place the car more reliably through entry and exit points on the track.

Installation and Compatibility Advice

This steering arm is produced for TG10-Mk.2 fitment, so installation is straightforward and usually requires only basic RC tools. Verify alignment after fitting to ensure optimal handling.

Can I use this on an older TG10 variant?

It is designed for TG10-Mk.2 geometry. Older TG10 variants may differ in mounting detail, so compare the mount points before fitting.

Is any setup needed after replacement?

After installing the steering arm, check toe and caster settings and confirm there is no binding in the steering linkages. Minor trim may be needed for perfect alignment.

What maintenance keeps the arm reliable?

Regularly inspect for wear at pivot points, keep ball studs lubricated if applicable, and replace the arm if you see deformation or excessive play.

Are spare fasteners included?

Parts like this often ship as the single component. Keep spare screws and washers on hand from your maintenance kit to avoid delays during fitting.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved