Tamiya 51126 - TG10-Mk.2 Race-Grade Wheel Axle  [51126]

Tamiya 51126 - TG10-Mk.2 Wheel Axle SP-1126
Price:
NZD$18.28
Brand:
Tamiya
Model:
51126
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Track-Ready Replacement for TG10-Mk.2 from Tamiya

When you need a reliable spare for the TG10-Mk.2, the Tamiya 51126 - TG10-Mk.2 wheel axle is made to restore precise wheel alignment and reduce play. It is a practical part for those who service their cars often and want predictable handling.

Engineered for Accurate Fit

The Tamiya 51126 - TG10-Mk.2 axle is manufactured to suit the TG10-Mk.2 mounting pattern so it installs cleanly. Proper fit helps keep suspension geometry stable and wheel tracking true under cornering loads.

Good for Setup and Maintenance

Use this axle as a maintenance item to refresh worn components and retain consistent steering feel. The precise dimensions of the Tamiya 51126 - TG10-Mk.2 support repeatable setups across practice and race days.

Can I reuse my current wheel bearings with this axle?

In most cases existing bearings can be reused if they are in good condition. Inspect for play and roughness and replace bearings if they show wear before fitting the axle.

Will the axle change my toe or camber settings?

As a like-for-like part it should not alter factory geometry, but always double check alignment after installation and adjust toe and camber if needed during setup.

What basic tools are needed to fit the axle?

Typical RC hand tools are sufficient: hex drivers, pliers for clips, and a torque driver if available. Work methodically and verify hub and bearing seating for a clean fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved