Tamiya 51461 TA06 Main & Middle Shaft Service Kit  [51461]

Tamiya 51461 - TA06 Main & Middle Shaft SP-1461
Price:
NZD$9.48
Brand:
Tamiya
Model:
51461
GTIN:
4950344514618
Condition:
Brand New
Write a review

Restore TA-06 drivetrain accuracy with Tamiya 51461 TA06

The Tamiya 51461 TA06 Main & Middle Shaft provides the replacement parts needed to keep a TA-06 running smoothly. It focuses on restoring correct driveline geometry to maintain predictable handling during club sessions and practice runs.

Built for correct alignment and endurance

These shafts are manufactured to fit TA-06 specifications, giving a snug, reliable fit that supports steady power transfer. Consistent alignment reduces wear on gears and bearings and keeps setup tuning consistent lap after lap.

Installation and maintenance guidance

When fitting the Tamiya 51461 TA06 shafts, clean contact points and verify bearing play. Set gear mesh carefully and recheck after a short run. Routine inspection and light lubrication will extend service intervals.

Can I use these shafts in a modified TA-06 with different bearings?

You can, but confirm bearing sizes and shaft tolerances. Some modified setups may need spacers or minor trimming to maintain correct alignment.

What lubricants are recommended for the shafts?

Use light bearing oil for bearings and appropriate gear grease on mating gears. Avoid heavy oils that attract grit and increase wear.

How can I check if the shaft needs replacing?

Look for scoring, bends, or excess play at the bearing seats. If you notice inconsistent power delivery or wobble, replace the shaft promptly.

Will this part affect handling balance?

A correctly fitted shaft keeps drivetrain behavior predictable, which helps maintain the handling balance you set with suspension and gearing.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved