Tamiya 5305063 TB Evo IV Front Stabiliser Upgrade  [5305063]

Price:
NZD$12.16
Brand:
Tamiya
Model:
5305063
Condition:
Brand New
Write a review

Keep the Nose Firm in Corners

The Tamiya 5305063 Front Stabilizer is made to suit the TB Evo IV chassis and improves front-end stability through turns. This practical hop-up helps drivers keep the car steady under load, giving more predictable steering on entry.

Fitment Notes and Quick Mount

Designed specifically for TB Evo IV, the stabilizer fits existing mounting points for a reliable install. Fitting is straightforward with common hand tools and takes only a short workshop session. After fitting, drivers will notice reduced understeer on medium to fast corners.

Can I use this with aftermarket steering blocks?

It can work with many aftermarket steering blocks if the mount points remain standard, but confirm clearance before final assembly.

Will this change ride height?

The stabilizer itself does not alter ride height, though you may adjust springs or droop to fine tune handling after installation.

Is any shimming required?

Most installs need no special shims, but check for bind and correct play during setup and add thin washers if needed for smooth operation.

Does it help on low traction surfaces?

The stabilizer reduces roll, which can aid front feel on lower traction, but tyre choice and shock tuning remain primary factors.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved