Tamiya 53278 Slim Aramid Drive Belt for TA03 Chassis [53278]

Tamiya 53278 - Armed Fiber Drive Belt TA03 OP-278

Price:

NZD$19.50

Brand:

Tamiya

Model:

53278

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - TA-03

Strength and Slim Profile for TA03 Drivetrains

The Tamiya 53278 Aramid Fiber Reinforced Drive Belt brings a balance of toughness and slim geometry to the TA03 chassis. Aramid fibers give high tensile strength while allowing a reduced cross section, helping the belt run smoothly and maintain alignment under load.

Notable Characteristics

Material: Aramid construction for reliable tensile resistance
Design: Thinner cross section to minimise bulk while preserving durability
Compatibility: Specifically made to suit the Tamiya TA03 layout

Can this belt cope with modified motors and higher RPMs?

The aramid reinforcement helps resist stretch under higher loads, but always check pulleys and alignment when increasing motor power to avoid premature wear.

How should I set belt tension for best results?

Aim for firm tension with a small amount of give by hand. Too loose will cause slippage, too tight can strain bearings. Fine tune with test runs.

Is any special tool required to install the belt?

No specialised tools are needed; basic shop tools and a check of pulley alignment will let you fit the belt to a TA03 with the standard setup.