Tamiya 53432 TGR Twin Pinion Pack  [53432]

Tamiya 53432 - TGR 2-Speed Pinion Gear 17T/21T OP-432
Price:
NZD$15.95
Brand:
Tamiya
Model:
53432
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-Tune Your TGR Chassis Gearing

Update your Tamiya TGR chassis using the 53432 2-speed pinion gear pack, which includes 17T and 21T pinions to help you adjust acceleration and top speed on smoother layouts. These pinions are intended for vehicles fitted with the TG10 2-speed gearbox.

Built for Consistent Track Performance

The Tamiya 53432 pinion set gives repeatable engagement and helps reduce unwanted backlash when properly meshed. Racers can swap between the two pinions to suit their course without altering the transmission internals.

Quick Change Procedure

Swapping pinions is straightforward: remove the existing pinion and install either the 17-tooth or 21-tooth gear supplied. After fitting, verify gear mesh and secure the pinion to prevent slippage under load.

Is the 53432 set compatible with older TGR chassis?

Compatibility depends on whether the older chassis uses the TG10 2-speed transmission or the same pinion spline. If it does, the pinions should fit; otherwise check dimensions before fitting.

Do I need special tools to set the gear mesh?

Basic hand tools are adequate, but using a small feeler or shim and a reliable driver helps you achieve an optimal mesh for quieter, longer-lasting operation.

Which pinion is best for short circuits?

Short, technical circuits often benefit from the 17T pinion for snappier acceleration, while the 21T suits longer straights where higher top speed is preferable.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved