Tamiya 53546 Setting Spring Set for TGM-02 Off-Road Tuning  [53546]

Tamiya 53546 - Setting Spring Set TGM-02 OP-546
Price:
NZD$32.14
Brand:
Tamiya
Model:
53546
Condition:
Brand New
Write a review

Optimise TGM-02 Shock Response with Tamiya 53546

The Tamiya 53546 Setting Spring Set is a straightforward way to dial suspension behaviour on the Tamiya TGM-02. It gives clear spring rate options so you can adjust for better traction or a softer ride as needed.

Three Distinct Spring Rates

This spring set contains three types, each easily identified by colour. The green springs deliver the softest action, red springs give a medium firm setup, and yellow springs are the firmest choice for minimal body roll. Switching between them helps you match the car to different tracks and surfaces.

Compatibility and Key Measurements

Specifically produced for the TGM-02, these springs install on standard shocks without extra parts. The springs are 76mm long with a 17mm inner diameter, so confirm those figures if fitting to other shock bodies.

Can I use these springs on a different make of car?

They are intended for the TGM-02. Other cars may accept them only if shock length and inner diameter match the 76mm and 17mm measurements.

Which spring works best for grass or gravel?

Try green for softer surfaces like short grass to keep traction, and red or yellow for rough gravel where you need more resistance to bottoming out.

Will I need to change droop or preload after swapping springs?

Yes, when you change spring rates expect to tweak preload and droop so both sides of the car maintain even ride height and balanced handling.

How do I store spare springs to keep them in good condition?

Keep them dry and out of sunlight, stored flat or hanging to avoid warping. Label colour and rate so you can swap quickly at the track.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved