Tamiya 53635 Super Hard Springs for TRF414m-WCR and TA04  [53635]

Tamiya 53635 - Super Hard Spring OP-635
Price:
NZD$10.22
Brand:
Tamiya
Model:
53635
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Dial In Grip with Tamiya 53635 Steel Shock Springs

The Tamiya 53635 Super Hard Shock Springs use hardened steel to stiffen the suspension on TRF414m-WCR, TB-EVOIII and TA04 chassis. These springs are intended for higher-traction layouts where firmer springs improve predictability under throttle and braking.

Best Use on High Traction Tracks

When running on carpet or well-prepped asphalt, these super hard springs give crisper turn-in and reduced roll. They help keep tyre contact more consistent during high-speed direction changes.

Compatibility and Installation Notes

Each pack contains two springs; fitment for a complete car requires two packs. Installation follows standard shock rebuild steps and the springs measure 25mm long with a 16mm diameter to suit the listed chassis models.

Will these change ride height on my car?

Ride height may change slightly depending on preload and shock spacing, but the primary effect is a stiffer spring rate rather than a large height shift.

Are two packs included enough for both axles?

No, one pack contains two springs so you will need two packs to replace springs on all four corners.

Should I change shock oil when fitting these?

Many users pair stiffer springs with slightly heavier shock oil to control rebound. Test gradually to find the right balance for your track conditions.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved