Tamiya 53636 Ultra Hard Shock Springs - Ultra Hard Track Set  [53636]

Tamiya 53636 - Ultra Hard Spring OP-636
Price:
NZD$10.89
Brand:
Tamiya
Model:
53636
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Dial In Track Performance with Tamiya 53636 Springs

For tuners seeking firmer suspension response on high-traction layouts, the Tamiya 53636 Ultra Hard Shock Springs provide a reliable upgrade. Engineered for TRF414m-WCR, TB-EVOIII, and TA04 chassis, these springs are crafted from robust steel to resist fatigue.

Designed for Sticky Surfaces

The extra-stiff rate helps decrease roll and maintain chassis balance when grip levels are high. The steel construction keeps the spring rate consistent during repeated sessions.

What Comes in the Pack

Each pack supplies two shock springs, which cover one end of the car; you will need two packs for a complete set. The springs measure 1 inch (25mm) long and 0.63 inches (16mm) in diameter to fit compatible shock assemblies.

Are these springs a good match for front suspension tuning?

Yes, they are commonly used up front to reduce dive and sharpen steering on high-grip circuits, though damping adjustments may be needed.

Do they change ride height?

Spring length is the same as standard 1 inch (25mm) units, so ride height is largely unchanged; the main difference is a firmer spring rate.

How should I maintain these springs?

Keep them free of grit and inspect for bends or corrosion; a quick wipe after running and occasional rust prevention will extend service life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved